First time setup —continued, Speaker configuration – Onkyo HT-R640 User Manual

Page 42

Advertising
background image

42

First Time Setup

—Continued

With these settings, you can specify which speakers are
connected and a crossover frequency for each speaker.

The following crossover frequencies can be specified:
Full Band, 40 Hz, 50 Hz, 60 Hz, 80 Hz, 100 Hz, 120 Hz,
150 Hz, 200 Hz.
Specify Full Band for speakers that can output low-fre-
quency bass sounds adequately, for example, speakers
with a good sized woofer. For smaller speakers, specify
a crossover frequency. Sounds below the crossover fre-
quency will be output by the subwoofer instead of the
speaker. Refer to your speakers’ manuals to determine
the optimum crossover frequencies.

Speaker Configuration

1

Press the [RECEIVER] or [AMP]
button followed by the [SETUP]
button.

The main menu appears onscreen.

MUTING

PREVIOUS

MENU

GUIDE

TOP MENU

SETUP

RETURN

PLAYLIST/CAT

PLAYLIST/CAT

--/---

TAPE/AMP

M D/CDR

HDD

CABLE

STANDBY/ON

DIMMER

ENT

D TUN

SLEEP

10

11

12

INPUT SELECTOR

REMOTE MODE

V

1

V

4

V

2

V

3

C D

TAPE

TUNER

DVD

MULTI CH

T V

VOL

VOL

SAT

VCR

T V

DVD

RECEIVER

C D

INPUT

+10

0

CLR

1

2

3

4

5

6

7

8

9

ENTER

CH

DISC

ALBUM

1, 11

2-10

2

1

RECEIVER

AMP

SETUP

2

Use the Up and Down [

]/[

]

buttons to select “1. Speaker
Config,” and then press [ENTER].

The Speaker Config menu appears.

3

Use the Up and Down [

]/[

]

buttons to select “a. Subwoofer,”
and then use the Left and Right
[

]/[

] buttons to select:

Yes: Select if a subwoofer is con-

nected.

No: Select if no subwoofer is con-

nected.

4

Use the Up and Down [

]/[

]

buttons to select “b. Front,” and
then use the Left and Right [

]/

[

] buttons to select a crossover

frequency.

Note:
If the Subwoofer setting in step 3 is set
to No, this setting is fixed at Full Band.

5

Use the Up and Down [

]/[

]

buttons to select “c. Center,” and
then use the Left and Right [

]/

[

] buttons to select a crossover

frequency.

If no center speaker is connected, select
None.

Note:
If the Front setting in step 4 is set to
anything other than Full Band, Full
Band cannot be selected here.

1.Speaker Config
------------------------
a.Subwoofer :Yes
b.Front : 100Hz
c.Center : 100Hz
d.Surround : 100Hz
e.LPFofLFE : 120Hz
f.DoubleBass :---

Advertising