Oki 4M User Manual
Page 55
3 - 19
3.3.12 Separator Guide
(1) Dismount the upper cover assy. (See Section 3.3.4.)
(2) Dismount the high-voltage power supply board. (See Section 3.3.5.)
(3) Remove four screws
1
.
(4) Dismount inlet
2
from base frame
3
.
<Dismounting inlet
2
>
Insert a screwdriver into the hole on the side of base frame
3
, remove the inlet claw from
base frame
8
, and dismount inlet
2
.
(5) Disconnect three cables
4
and connector
A
and dismount base frame
3
. Then, remove
screw
0
and disconnect FG cable
B
.
<Disconnecting connector
A
>
Dismount connector
A
by drawing it upward while pushing the clamp lever with a standard
screwdriver.
(6) Dismount the paper holder assy. (See Section 3.3.7.)
(7) Dismount two engagements and sheet guide
5
.
(8) Dismount friction pad
6
, compression spring S
7
, and separator guide
8
.
(9) Dismount paper sensor E
9
.