Onkyo TX-L5 - Manual (Page 8)

8
SN 29343138 TX-L5.E
For operational instructions, refer to the page indicated in brackets.
■ Front panel
Index to Parts and Controls
1 POWER switch [19]
Turns on the main power supply for the TX-L5. The
TX-L5 enters standby state and the STANDBY indicator lights up.
Pressing the switch again to the off position (
— OFF) shuts down the
main power supply into the TX-L5.
• Before turning on the power, make sure all cables are properly
connected.
• Turning on the TX-L5 may cause a momentary power surge that
might interfere with other electrical equipment on the same
circuit. If this is a problem, plug the TX-L5 into a different
electrical circuit.
2 STANDBY/ON button, ON indicator, STANDBY indicator
[19]
When STANDBY/ON button is pressed to ON while the POWER
switch is set to ON, the display will light to show the current volume
setting for about 5 seconds then show the current sound input
source and listening mode. Pressing the button again returns the
TX-L5 to the standby state. This state turns off the display, disables
control functions.
3 Source indicators [23, 26]
One of these indicators lights to show the current source.
4 Remote control sensor [7]
This sensor receives the control signals from the remote controller.
5 Display [9]
6 INPUT dial [23, 26, 35]
The INPUT dial is used to select the input source.
7 VOLUME dial [23, 26]
The VOLUME dial is used to control the volume level. Turn the dial
clockwise to increase the volume level and counterclockwise to
decrease it.
SUBWOOFER MODE SURROUND STEREO
ON
STANDBY
POWER
STANDBY / ON
ON OFF
PHONES ACOUSTIC CONTROL TUNING/PRESET
DVD / C D VIDEO 1 VIDEO 2 H D MD / TAPE
FM AM
INPUT
VOLUME
AV RECEIVER TX-L 5
MEMORY FM MODE
1 2 3
8 9 0 - = ~ ! @
4 5 6 7
8 PHONES jack [29]
This is a standard stereo jack for connecting stereo headphones.
The audio for the front right and left speakers are sent to the
headphone speakers. When the headphones are plugged in, the
listening mode automatically changes to STEREO and sounds are
not output from the speakers.
9 SURROUND button [32]
Press this button to select a surround mode for current input source.
0 STEREO button [32]
Press this button to change the sound to stereo.
- SUBWOOFER MODE button [20]
Press to select the subwoofer mode.
= MEMORY button [24, 25]
This button is used to assign the radio station that is currently tuned
in to a preset channel or delete a previously preset station.
~ FM MODE button [23, 25]
Press to switch the reception mode between stereo and monaural. If
audio is interrupted or noise interferes with audio during FM stereo
broadcasting, press this button to switch to the monaural reception
mode.
! TUNING/PRESET ™/£ button [23, 24]
Use these buttons to change the tuner frequency. The tuner
frequency is displayed in the front display and it can be changed in
50 kHz increments for FM and 10 kHz (or 9 kHz) increments for AM.
Also, These buttons make it possible to store desired radio stations
under the desired preset numbers and recall them with an easy
operation.
@ ACOUSTIC CONTROL button/indicator [34]
Press to change the acoustic mode to enjoy more dynamic sounds
by boosting the super bass/high frequency sounds.