Onkyo PR-SC886 - Manual (Page 60)

60
First Time Setup
—Continued
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1 Turn on the AV controller and the
connected TV.
On the TV, select the input to which the
AV controller is connected.
2 Place the speaker setup micro-
phone at measurement point
1
(page 59), and connect it to the
SETUP MIC jack.
Notes:
• Before starting Audyssey MultEQ
®
XT
Automatic Speaker Setup, arrange
the room and connect the speakers as
you would for enjoying movies.
Changes to the room after auto setup
requires you run the auto setup again,
as room EQ characteristics may have
changed.
• When starting the automatic speaker
setup, do not stand between the
speakers and microphone, and avoid
obstacles blocking the path between
speakers and microphone. This will
produce inaccurate results.
• Position the microphone at ear height
of a seated listener with the micro-
phone tip pointed directly at the ceil-
ing using a tripod. Do not hold the
microphone in your hand during
measurements as this will produce
innacurate results.
• Make the room as quiet as possible.
Background noise can disrupt the
room measurements. Close win-
dows, silence cell phones, televi-
sions, radios, air conditioners,
fluorescent lights, home appliances,
light dimmers, or other devices.
• Cell phones should be turned off or
placed away from all audio electron-
ics during the measurement process
as Radio Frequency Interference
(RFI) may cause measurement dis-
ruptions (even if the cell phone is not
in use).
Auto Speaker Setup
Please place microphone at center of listening area at
ear height.
Next
ENTER ENTER
1
3 Press [ENTER].
The automatic speaker setup starts.
Test tones are played through each
speaker as Audyssey MultEQ
®
XT
Automatic Speaker Setup runs. This
process takes a few minutes. Please
refrain from talking during
measurements and do not stand
between speakers and the microphone.
4 The speaker detect results
appear.
“Yes” means that the speaker was
detected. “No” means that no speaker
was detected.
If you agree with the results, use
the Up and Down [ ]/[ ] buttons
to select “Next”, and then press
[ENTER].
The options are:
Next: Proceed to the next step.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker
setup.
5 The following screen appears.
Place the setup microphone at
the next position (see page 59),
and then press [ENTER].
Audyssey MultEQ
®
XT performs more
measurements. This takes a few minutes.
Auto Speaker Setup
Do not unplug Setup Mic.
Please keep quiet.
Now measuring. . .
2
Auto Speaker Setup
Speaker Detect Result
Next
Retry
Cancel
ENTER ENTER MOVE
:Yes :No
Auto Speaker Setup
Please place microphone at next position at ear height.
Next
ENTER ENTER
2
Auto Speaker Setup
Do not unplug Setup Mic.
Please keep quiet.
Now measuring. . .
2