Onkyo PR-SC886 - Manual (Page 62)

62
First Time Setup
—Continued
Error Messages
While the automatic speaker setup is in progress, one of
the following error messages may appear:
❑ Ambient noise is too high
This message appears if the background noise is too loud
and the measurements cannot be performed properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the automatic speaker setup.
❑ Speaker Detect Error
This message appears if a speaker is not detected. “Yes”
means that a speaker was detected. “No” means that no
speaker was detected. Check your speaker connections
and retry, or cancel the automatic speaker setup.
The front right speaker has not been detected.
The surround right speaker has not been detected.
The surround back left speaker has not been detected.
There is a problem with the front left speaker. If the
warning triangle (
) appears for the subwoofer, it may
be that the output from the subwoofer is too loud.
The number of speakers detected on the second or third
measurement was different to the number detected on
the first measurement.
Make sure speakers that cannot be detected are con-
nected property.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
❑ Writing Error!
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV controller is probably malfunctioning.
Contact your Onkyo dealer.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
Auto Speaker Setup
Ambient noise is too high.
Retry
Cancel
ENTER
!
ENTER MOVE
Auto Speaker Setup
Next
Cancel
:Yes
:---
:No
:Error
ENTER ENTER
Speaker Detect Error !
MOVE
!
Auto Speaker Setup
Next
Cancel
:Yes
:---
:No
:Error
ENTER ENTER
Speaker Detect Error !
MOVE
!
Auto Speaker Setup
Next
Cancel
:Yes
:---
:No
:Error
ENTER ENTER
Speaker Detect Error !
MOVE
!
Auto Speaker Setup
Next
Cancel
:Yes
:---
:No
:Error
ENTER ENTER
Speaker Detect Error !
MOVE
!
Auto Speaker Setup
Next
Cancel
:Yes
:---
:No
:Error
ENTER ENTER
Speaker Detect Error !
MOVE
!
!
Auto Speaker Setup
Speaker Detect Error
Retry
Cancel
ENTER
!
ENTER MOVE
Auto Speaker Setup
Writing Error!
Retry
Cancel
ENTER
!
ENTER MOVE