SEVERIN TO 2036 User Manual

Page 10

Advertising
background image

close to or underneath any wall-cupboards
or hanging objects such as curtains or any
infl ammable materials.
During operation, the appliance must

z

be placed on a heat-resistant surface,
impervious to splashes and stains. Do
not position the appliance on or near
hot surfaces, open fl ames or infl ammable
vapours.
Caution:

z

the pizza stone becomes very

hot during use, and will only cool down
very slowly aft er the appliance has been
switched off and disconnected from mains
power. Th

ere is a severe danger of burns in

any case of contact.
Always let the pizza stone cool down

z

completely before it is removed from the
appliance.
Caution:

z

do not place aluminium foil or

anything similar between the grill rack and
the pizza stone. Place the stone directly
onto the rack.
Do not allow the power cord to touch any

z

hot parts of the appliance.
Do not let the power cord hang free.

z

Always switch off and remove the plug

z

from the wall socket aft er use, as well as

in cases of malfunction, and

-

during cleaning.

-
When removing the plug from the wall

z

socket, never pull on the power cord;
always grip the plug itself.
No responsibility is accepted if damage

z

results from improper use, or if these
instructions are not complied with.
Th

is appliance is intended for domestic use

z

only and not for commercial applications.
In order to comply with safety regulations

z

and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer service departments. Th

e

address can be found in the appendix to
this manual.

Temperature control
With the temperature control knob, the
temperature can be set to the desired level.

5-position switch settings

z Both heating elements and rotating spit

switched off .

Upper heat

Upper heat with rotating spit

Upper heat and lower heat

Lower heat

Th

e heating elements will only be switched

on aft er the timer is activated.

Timer
By using the timer, the cooking time can be
selected up to a maximum of 60 minutes.
To set a time of less than 10 minutes, turn the
timer to a somewhat higher setting fi rst and
then slowly turn it back to the desired time
setting. Aft er the pre-programmed time has
elapsed, an acoustic signal indicates that the
heating elements are switched off . To switch
off the entire appliance, the heating elements
must be switched off as well.

Indicator lamp
Th

e indicator lamp lights up when the

appliance is switched on. It goes out once the
pre-programmed time has elapsed, or if the
switch is turned back to position 0.

Hot-air convection
Th

e hot-air convection fan is activated

automatically whenever the heating elements
are switched on.

Rotating spit
When using the rotating spit, only the upper
heating function is used.

Before the spit is used, always ensure that

the baking tray is properly inserted into
any of the guide rails.
When the food to be cooked is put onto

z

the spit, make sure that it cannot come
into contact with either the upper heating
elements or the baking tray; ensure

10

Advertising