Telular CDMA 2000 1X - Manual (Page 12)

Data Features
The SX4P allows for 1X packet data and circuit switched data (CSD) using a PC connected to
the data port of the SX4P.
Making Data Calls
To make any data call from the SX4P, the unit must be in data mode. Only data calls can be
made when the SX4P is in data mode. If you want to make a voice call while in data mode,
press the Flash key then wait for the SX4P to configure. It will now be in voice mode.
1. Press the FLASH key.
2. Select Data Mode. The display will show Data Mode: Press Flash to Exit.
3. The SX4P is now in data mode where you can place a data call from a device connected to
the data port.
4. To exit this mode press the FLASH key. The SX4P will reconfigure itself for voice mode.
Receiving Data Calls
The SX4P must be configured to receive data calls. A menu option allows setup of whether the
SX4P can accept circuit switched data calls, circuit switched fax calls, or voice calls. When this
option is set, only the specified type of call can be received. If you select fax calls, then you will
only be able to receive fax calls to the data port of the SX4P. You will not be able to receive
voice calls if you are not in voice mode and Call Bearer is not set to 2 (Voice). The default
received call type is voice.
1. Enter the user menu by pressing the FLASH key.
2. Select Settings then Call Bearer.
3. Enter the desired call mode.
0 = Data
1 = Fax
2 = Voice (default)
4. The SX4P must be in data mode before a data call can be received. To switch to data mode,
select the Data Mode option from the main menu.
5. Now you can receive data calls. To receive voice calls you must switch back to voice mode
and set the Call Bearer to 2.
Note: When in circuit switched data mode CSD will be displayed. When in fax mode FAX will be
displayed.
Data Connectivity Kit
A special data kit must be used to allow data connectivity to the SX4P. For more information on
this kit, contact your service provider or nearest Telular dealer.
Voicemail
Set Voicemail Access Number
1. Press the FLASH key, then select Settings.
2. Select Voice Mail Number.
3. Enter the appropriate number to access the voicemail sys-
tem. Contact your service provider for this number.
4. Press the FLASH key.
Access Voicemail
1. Lift the handset or press the Redial/Hands-free key to go off-hook.
2. Press the Voicemail key.
3. Follow automated instructions.
NOTE: Set the voicemail access number before attempting to access voicemail.
Phonecell ® SX4P 1x 8 User Manual
Set Voicemail Access
Number.