Telex Firefly P200 - Manual (Page 16)

OPERATION
After you have connected the Firefly ™ P200/P250 as described in the
P200/P250 Setup section of this manual, you are ready to begin using
your P200/P250 LCD notebook projector.
Basic Operation
1. Lift and rotate the mirror as shown in Figure 6.
2. Press POWER to turn on the P200/P250 LCD notebook projector.
The keypanel will light up and the projector lamp will turn on; initially
the screen will be blue. After initialization, the Telex logo will appear.
WARNING! To prevent burns when the P200/P250 is operating,
avoid touching the lamp access door and the surrounding area.
3. Turn on the attached computer. The Telex logo will disappear and
the computer image will appear.
CAUTION! The cooling fans protect the Firefly ™ P200/P250 from heat
generated by the projector lamp. Always make sure that the air intake
and exhaust are not blocked.
4. Adjust the room lighting for optimum screen viewing. (The projector
lamp is automatically turned on when the P200/P250 is turned on.)
5. Adjust the mirror angle for best screen image. (You may press the
POWER button to turn off the projector and lamp until your
presentation begins.)
6. Adjust the screen focus by rotating the lens (Figure 10).
NOTE: The keypanel and on-screen control settings will be the same as
they
were when the P200/P250 was last used, if ten seconds were
allowed to elapse before the P200/P250 was disconnected from the AC
wall outlet.
7. To improve the image phase adjustment, display a colorful image on
the computer screen and select the on-screen
FOCUS control. (It is
easier to adjust the Firefly ™ P200/P250 with a colorful image.)
8. Turn on your audio source (CD player, wireless microphone,
amplifier auxiliary audio output, etc.).
☞
User Manual 11