Telex Firefly P200 - Manual (Page 20)

NOTE: The Alignment controls are functional only when the P200/P250
is not in “menu” mode.
MENU This key controls the display of the on-screen controls “menu.” If an
on-screen controls “menu” item is displayed, pressing this key will make
the display disappear (on-screen displays normally disappear after five
seconds). To enter “menu” mode and access the on-screen controls,
press and release
MENU/RESET , then press either the up or down
arrow key to “step” through the “menu” until the desired Menu Mode
On-Screen Control is displayed. When the P200/P250 is in on-screen
“menu” mode, only the Menu Mode On-Screen Controls are functional.
RESET To reset the Firefly ™ P200/P250 image to the original factory settings,
press and hold MENU/RESET until the on-screen display indicates
READY TO RESET (approximately five seconds). When the key is
released the P200/P250 will reset, clearing all image enhancements that
you have made, restoring the factory settings as the default settings. (If
MENU/RESET is released before READY TO RESET is displayed, the
factory settings will not be restored.)
SOURCE Press SOURCE to select video input from COMPUTER , VIDEO , SVHS
jacks. If only one video source is “live,” the screen will go blank for a
moment, then return control to the “live” video source.
F1, F2 The F1 and F2 keys can be programmed as shortcuts to any Menu
Mode On-Screen control that you feel you regularly need to use without
going through the on-screen “menu” to access. To begin programming
the
F1 or F2 key, first access the desired Menu Mode On-Screen
Control, then press F1 or F2 and the F1 on-screen graphic will appear.
Press F1 or F2 a second time to program the key for the selected Menu
Mode On-Screen Control. The F1 or F2 key will now access the
selected Menu Mode On-Screen Control. If you do not press F1 or F2 a
second time within five seconds, the F1 and F2 programs will remain
unchanged.
REPLACE LAMP The REPLACE LAMP indicator lights when the lamp hour value reaches
zero. Use the LAMP HOURS On-Screen Control to reset the lamp hour
value and extinguish the REPLACE LAMP indicator.
POWER Press POWER to turn off the projector and lamp. Press POWER again
to turn on the projector and lamp.
☞
User Manual 15