TOA Electronics SPEEDTOUCH 570 - Manual (Page 22)

3EC 17766 BAAA TCZZA Ed. 01
1 SpeedTouch™570 Installation
22
The configuration
procedure
Step Action
1 Once the the SpeedTouch™ Setup wizard has detected the SpeedTouch™570
device you can proceed with the configuration procedure.
If more than one SpeedTouch™ device is listed, select the appropriate one.
Then, click Next to proceed.
Note If the SpeedTouch™570 has been configured before, it may be
protected by a system password. You must provide this password
before you can view the device details or continue with the config-
uration.
2 The following window invites you to select the appropriate connection profile
for your Internet connectivity:
Select the connection profile and click Next to continue.
Note If the Service Provider included a separate disk with a dedicated
connection profile, click Have disk to navigate to the location of
the appropriate connection profile file.
3 Subsequent screens will guide you through the configuration setup of both
your SpeedTouch™570 and/or your PC. Follow the instructions and enter the
required information where needed. This information should be provided by
your Service Provider.
4 In final step all configurations will be applied to the SpeedTouch™570 and
your PC. You can follow the configuration progress in following window: