TP-Link TD-W8970N - Manual (Page 28)

TD-W8970N Wireless N ADSL2+ Modem Router User Guide
)
Note:
The following section adopts different VPI, VCI to introduce further configuration for the different
connection types, if you need to change the configuration of ATM PVC (VPI/VCI), you should go to
the previous section (
4.4.1 Layer2 Interface ) to configure them again.
)
Note:
ETH and ATM service can not coexist. If the ETH Interface had configured, you cannot configure
any other WAN service over the ATM Interface until the ETH Interface is deleted.
4.4.2.1 ATM-EoA-PPPoE
If your ISP provides a PPPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a
new
ATM interface and select EoA option for DSL Link Type ( 4.4.1.1 ATM interface ).
2. Click the Add button on the screen Figure 4-7 and you will enter the next screen as shown in
Figure 4-8. Click Next.
Figure 4-8
3. Select the WAN service type in Figure 4-9. If your ISP provides a PPPoE connection, select
PPPoE option. You can create a service name for the Service Description or leave it the
default name. Click Next.
21