Yamaha DVD-C900 - Manual (Page 40)

36
1 2 3 4 5
DISC
PLAYXCHANGE OPEN/CLOSE
SKIP/SEARCH
/
O CD / CD
1 2 3 4 5
6
+10
7 8 9 0
A-B S/F CANCEL
ANGLE
SELECT TITLE AUDIO
MENU SUBTITLE
SET UP
ON SCREEN
OFF/ON
MULTI SPEED
RETURN TITLE/INDEX
REPEAT
DISC SKIP
PROG RANDOM
DISC MODE TIME
OPEN/
CLOSE
STOP STILL/PAUSE
SKIP/SEARCH
PLAY
To stop program play
Press STOP ( ).
* This unit memorizes the point where STOP ( ) was
pressed (Playback Resumption).
Press PLAY to resume playback from that point.
To cancel the program play mode (and restore the
normal play mode)
There are several methods. The following are some of them.
• Press STOP ( ) or PROG when the program play is
stopped with the point to resume playback memorized.
• Press DISC SKIP or DISC (1–5).
Note: These operations will not delete the program data.
Press PROG again to restore the program play mode.
To check and correct program data
1. If during playback, press STOP ( ).
* This unit memorizes the point where STOP ( ) was
pressed.
2. Press STOP ( ) again.
* The program play mode is canceled.
3. Press PROG.
* The list of the program data is shown on the monitor
screen. (Refer to page 35 for details.)
4. If you want to correct an already programmed selection,
select it by pressing / / / .
5. Select a new title (or track) you want to reprogram.
* Select the disc number by using DISC SKIP or DISC
(1–5) and select the title (or track) number by using the
numeric buttons.
* The already programmed title (or track) will be cleared
from the memory and the new one will be programmed.
6. If you correct more selections, repeat step 5.
7. When the check or correction is finished, press PLAY.
To clear all program data
• Open the disc table by pressing OPEN/CLOSE or
PLAYXCHANGE.
• Follow steps 1 to 3 of “To check and correct program data”
described above, and then press and hold CANCEL for
more than 3 seconds.
/ (PLAY)
/
CANCEL
DISC SKIP
Numeric
buttons
PROG
OPEN/CLOSE
PLAY STOP ( )
Advanced operation
/ / /
PLAYXCHANGE
DISC (1–5)
OPEN/CLOSE