Tascam DS-M7.1 - Manual (Page 34)

34
TASCAM DS-M7.1
8 – Specifications
The following information is provided for reference
when connecting the DS-M7.1 to other equipment.
Always take care when making these connections. This shows the pinouts when viewing the rear panel
of the DS-M7.1.
Analog connections
The pinouts for the 25-pin D-sub connectors used for
both analog input and analog output are as follows:
AES/EBU connections
The pinouts The pinouts for the 25-pin D-sub con-
nectors used for AES/EBU I/O (insert and monitor,
as well as are as follows:
13 1
14 25
Pin Signal Pin Signal
1 CH 8 + 2 CH. 8 Gnd
3 CH. 7 – 4 Ch. 6 +
5 CH. 6 Gnd 6 CH. 5 –
7 CH. 4 + 8 CH. 4 Gnd
9 CH. 3 – 10 CH. 2 +
11 CH. 2 Gnd 12 CH. 1 –
13 NC 14 CH. 8 –
15 CH. 7 + 16 CH. 7 Gnd
17 CH. 6 – 18 CH. 5 +
19 CH. 5 Gnd 20 CH. 4 –
21 CH. 3 + 22 CH. 3 Gnd
23 CH. 2 – 24 CH. 1 +
25 CH. 1 Gnd
Pin Signal Pin Signal
Pin Signal Pin Signal
1 D. Out 4 + 2 Gnd
3 D. Out 3 – 4 D. Out 2 +
5 Gnd 6 D. Out 1 –
7 D. In 4 + 8 Gnd
9 D. In 3 – 10 D. In 2 +
11 Gnd 12 D. In 1 –
13 NC 14 D. Out 4 –
15 D. Out 3 + 16 Gnd
17 D. Out 2 – 18 D. Out 1 +
19 Gnd 20 D. In 4 –
21 D. In 3 + 22 Gnd
23 D. In 2 – 24 D. In 1 +
25 Gnd
Pin Signal Pin Signal