Tascam DS-M7.1 - Manual (Page 35)

8 – Specifications
TASCAM DS-M7.1
35
Specifications
I/O specifications
The CONSOLE , MASTER and INSERT connectors
may each have an optional slot card selected as alter-
native I/O sources.
These slots may be filled by any of the following (but
only one analog IF-AN/DM card may be fitted at a
time).
Also note that when such analog cards are fitted, the
headroom should be set on the cards to 20dB, using
the switches and jumpers on the cards, and following
the documentation supplied with thcards.
All these cards use PCI 120-pin edge connectors and
conform to the TASCAM TDMCS standard.
Analog monitor section
Analog CR inputs (stereo)
CONSOLE I./O TDIF-1 format (built-in) 8 channels each of input and output (25-pin D-sub) or
slot 1
TRK RECORDER I/O TDIF-1 format (built-in) 8 channels each of input and output (25-pin D-sub) or
slot 2
MASTER RECORDER I/O TDIF-1 format (25-pin D-sub)
AES-1992 (AES/EBU) format (25-pin D-sub)
ADAT (TOSLINK “lightpipe” format) x 2 (built-in), 8 channels each of input and
output
INSERT I/O AES/EBU (25-pin D-sub), balanced analog (25-pin D-sub x 2), 8 channels each
of input and output or slot 3
MONITOR OUTPUTS AES/EBU (25-pin D-sub), balanced analog (25-pin D-sub), 8 channels of output
WORD IN BNC , TTL level with 75
Ω
termination switch
MUTE/DIM remote connector TRS 3.5mm jack (common sleeve, tip=mute, ring=dim), TTL level input (falling
edge detection)
REMOTE IN (1 and 2) 9-pin D-sub connectors (1=front, 2=rear) for connection of the remote control
panel. Power +8V, Differential Tx and Rx
RS-232C 9-pin D-sub connector conforming to RS-232C standards
IF-AE/DM AES-1992 (AES/EBU) — can be used with high-speed mode
IF-AD/DM ADAT “lightpipe” interface (SYNC in this card is not available with the DS-M7.1)
IF-TD/DM TDIF card (REMOTE OUT connector not available with DS-M7.1)
IF-AN/DM Analog I/O (use with 20dB headroom) — can be used in high-sampling mode
Nominal output level +4dBu
Maximum output level +24dBu
Output impedance < 100
Ω
DAC resolution 24bits
Nominal input level +4dBu
Maximum input level +24dBu
Input impedance > 10k
Ω
ADC resolution 24bits