Pcmcia card recognition, Windows 95 (ti-installed) – Texas Instruments Adpater User Manual
Page 28
PCMCIA Card Recognition
On some TravelMate Pentium products, a PCMCIA Ethernet
card error may occur after DockMate installation. If this
happens, refer to the following sections (Windows 95,
Windows 95 Commercial Upgrade, or Windows for
Workgroups) depending on your operating environment.
Windows 95 (TI-Installed)
The following instructions should clear PCMCIA Ethernet
card problems in a TI-installed Windows 95 environment.
Reconfigure TI Setup
1.
Open the Windows Control Panel and select the TI
Setup icon.
2.
Select the System Configuration tab and set the
parameter for PCMCIA I/O Addresses to Maximum.
3.
Select the tab marked Ports-Dock A.
4.
Select DockMate for the Dock Type.
5.
Select Dock Parallel Port Extended Mode.
6.
Choose one of the following as the recommended
settings for docking:
❏
SPP is selected as Standard Parallel Port
❏
ECP and EPP is selected as Extended Parallel Port
(setting preferred for most users).
7.
Select OK.
8.
Reboot and proceed to Reconfigure System Information.
Reconfigure System Information
1.
Select the System icon in the Control Panel.
2.
Select the Device Manager tab.
PCMCIA Card Recognition
Troubleshooting Procedures 4-5