Operating the equipment remotely, Introduction, Remote ethernet (snmp) operation – TANDBERG TT1282 User Manual
Page 16: Basic unit set-up, Set the transport stream input, 1 set the transport stream input
TT128x High Definition Professional Receiver/Decoder
16
5
Operating the Equipment Remotely
5.1
Introduction
When an external control system is used the Receiver may be
configured, controlled and monitored remotely.
5.2
Remote Ethernet (SNMP) Operation
If the Receiver is to be controlled via its Ethernet interface the unit's IP
address and associated parameters must be set in the relevant menus.
Firstly, the unit’s IP address should be set (Menu 7.1.3). Then the unit
subnet mask should be set (Menu 7.1.3.1) and if the controlling device
is on a separate network accessed through a gateway router then the
gateway IP address should be set (Menu 7.1.3.2). Finally the operating
mode should be set to “NETWORK (SNMP)” (Menu 7.1). The SNMP MIB
for the IRD is available from TANDBERG Television.
6
Basic Unit Set-up
6.1
Set the Transport Stream Input
Navigate to the Input Menu (Menu 2.1/2.2) and select the transport
stream input source required. This menu always has options ASI or
SMPTE 310. Dependent upon what additional input option cards have
been fitted, G.703, QPSK or IP may also be selected.
ASI/SSI Input
No other parameters need be set.
G.703 Input
>
Set the Reed-Solomon (Menu 2.3.2)
>
Set the Interleaver (Menu 2.3.3)