Connecting up the basic receiver, 4 connecting up the basic receiver, Figure 2.1: rear panel connectors – TANDBERG TT1282 User Manual
Page 8: Table 2.1: types of connector
TT128x High Definition Professional Receiver/Decoder
8
2.4
Connecting Up the Basic Receiver
Always use the specified cables supplied for signal integrity and
compliance with EMC requirements (see the Reference Guide).
Only those connectors used are labelled in Figure 2.1 and described in
Figure 2.1: Rear Panel Connectors
Table 2.1: Types of Connector
Type of Connector
Description
Video Out
A 15-way D-type connector provides an RGB/HV (SVGA)
or YPrPb interface. The video output format is selectable
via the front panel.
AUDIO 1
A 9-way male D-type connector provides both analogue
and digital outputs simultaneously
AUDIO 2
A 9-way male D-type connector provides both analogue
and digital outputs simultaneously
FRAME SYNC
A 75 W BNC connector provides a frame lock mechanism
for the output analogue and digital video. The frame
sync input signal shall be a composite burst signal.
ASI/HDSDI
OUT 1 and 2
Video
Out
Audio
1 and 2
Frame
Sync
ASI/SMPTE
310 In
10/100BaseT
Alarm
Technical
Earth
RS-232/RS422
Data Out
WARNINGS
1. The Technical Earth is not a Protective earth for electric shock
protection.
2. This unit must be correctly earthed through the moulded plug
supplied. If the local mains supply does not have an earth
conductor do not connect the unit. Contact Customer Services for
advice.
3. Before connecting the unit to the supply, check the supply
requirements in Annex B of the Reference Guide.