Set the analogue video output options, Set the digital video output options, Set the transport stream output options – TANDBERG TT1282 User Manual
Page 17
TT128x High Definition Professional Receiver/Decoder
17
HOM/QPSK Input
>
Select the RF Input connector (Menu 2.3)
>
Set the LNB frequency (Menu 2.3.2)
>
Satellite frequency (Menu 2.3.2.1)
>
Symbol rate (Menu 2.3.2.2)
>
Modulation FEC (Menu 2.3.2.3)
>
LNB power (Menu 2.3.2.4)
>
LNB 22 kHz (Menu 2.3.2.5)
>
Frequency search range (Menu 2.3.2.6)
IP Input
>
Receive UDP port number (Menu 2.3.2)
>
Input IP address (Menu 2.3.2.1)
>
Input subnet mask (Menu 2.3.2.2)
>
Input gateway address (Menu 2.3.2.3)
>
Input multicast IP address (Menu 2.3.2.4)
6.2
Set the Analogue Video Output Options
Select RGB or YUV video output to match the requirements of the video
monitor being used (Menu 3.1.9).
Navigate to the Trisync Mode Menu (Menu 3.1.10) and select the mode
that matches the requirements of the video monitor being used – either
“ON GREEN”, “ON ALL” or “NONE”.
6.3
Set the Digital Video Output Options
Navigate to the HD SDI output selection menu (Menu 5.1) and select
the HD SDI to be output on either Connector 1 or Connector 2 or both.
6.4
Set the Transport Stream Output Options
Navigate to the ASI output selection menu (Menu 5.1) and select the
transport stream output (ASI) to be output on either Connector 1 or
Connector 2 or both.