Telos Zephyr iPort - Manual (Page 14)

8 | section 2
equipment, you’d have a rack full of codec boxes, expensive router interface cards, and a
plethora of cables.
If you don’t already have a Livewire installation, no problem. You can use an audio interface
Node, or two, and still benefit from the iPort’s simplicity and low cost.
Getting Started
A simple installation would look like the one in the block diagram above. In this case, a LW
Node is providing the audio interface. Both analog and AES3 Nodes are available. Since
each Node provides 8 inputs and 8 outputs, you have a perfect correspondence with the
channel capacity of the iPort. The Node could be connected with a small Ethernet switch.
You could then connect a PC for configuration to a spare port. Or you could use an Ether-
net cross-cable for a direct connection. The configuration PC would be connected only for
set-up, in advance of use, then disconnected. Or it could be connected to the WAN port, if
that has been configured to allow Web access.
�������� ��
�������������
������� ��
������ ����
����������
�������� ��
If you will be using the iPort within a facility that is already Livewire-equipped, the Node
will not be required. Just connect the LW port of the iPort to a free Ethernet port in your
system. Livewire sources may be from/to either Nodes or PC software drivers, however
there must be at least one hardware Livewire Node in the system to provide the required
clock signal to the network.
Most Livewire installations will be like that in the diagram above, with separate networks
for the Livewire audio and the general network, which has the WAN interface. The iPort is
ready for this case, with its two Ethernet interface ports. It keeps the two networks isolated.
However, some LW installations will have the audio and general networks combined.
Configuring the iPort
All configuration is via a Web interface. By default, this is accessible only via the Livewire
port, but access over the WAN port can be enabled.
The first step is to set-up the network values. Open a Web browser and point it to the IP
address of the iPort. For example: http://192.168.1.7. You will be asked for a user name and
password. The factory defaults are:
User name: user
Password: <blank>