Telos Zephyr iPort - Manual (Page 32)

26 | section 3
; ServIP=ANY
; SrcIP [*Any]: SrcIP is the IP that Steamcast will listen for source connections. For
; instance setting this option to 127.0.0.1 will limit SHOUTcast source connection attempts
; to only from the the machine steamcast resides on. ANY (case sensitive) will allow
; steamcast to bind to all and any ip interfaces available.
; SrcIP=ANY
; ThreadPool [*5]: Set this to control the amount of available threads for incoming clients.
; Generally you should not have to change this setting. Setting anything below 2 is not allowed,
; due to severe loss of performance. Setting this too high will mean more memory and overhead
; will be needed to load the server, be sensible if you must change this number. While you are
; allowed to set a number as high as 100 anything over 10 is generally considered excessive.
; ThreadPool=5
; MetaInterval [*8192]: Set this to control the meta data interval in bytes for audio types that
; utilize the Icy Meta Data protocol. This is a server wide option. Technical notes: Excessive
; CPU and unlistenable streams may result if you set this value too low. Steamcast will go no
; lower then 1024bytes.
; MetaInterval=8192
; if I could smile I would.
; We’ve configured one source; now we’ll do all the others, following the same pattern...
; Stream 2 is MPEG AAC. We have to use the .aac suffix so that player will know what decoder
; to use
SourceMount=/stream2.aac
SourceUser=telos2
SourcePass=telos2
SourceUserMax=5
SourceIsDefault=No
SourceMount=/stream3.mp3
SourceUser=telos3
SourcePass=telos3
SourceUserMax=5
SourceIsDefault=No
SourceMount=/stream4.mp3
SourceUser=telos4