Telos Zephyr iPort - Manual (Page 28)

22 | section 3
; ClientTimeout [*30]: Number of seconds a listener/viewer should stay connected while no
; source exists for thier mount.
ClientTimeout=30
; User Configuration
; ==================
; AdminUser & Admin Pass: This is the credentials that allow full control of the server remotely
; so be very careful in determining what to put here. Essentially with these settings
; a user would be able to connect to the server using a CNTRL application and use
; the server as if they are sitting in front of it. Please make sure that admin passwords are
; different from mount passwords in SHOUTcast compatibility mode. Encoders passwords take
; precedence in the event they are, this is for compatibility and security reasons.
AdminUser=telos1
AdminPass=telos1
; Source Configuration
; ====================
; Each source that you wish to allow on the server needs to be configured
; here first. The parser will read strait down the file so if you have
; multiple source mounts and you declare a new mount before finishing
; configuration of another, then those configurations after the new
; declaration will go to the new mount.
; SourceMount: This is the mount you would like to create, if you set
; this to /ghey then you would be able to access this mount by
; going to http://localhost:8000/ghey It is critical that you
; make sure to include the slash at the beginning.
SourceMount=/stream1
; SourceUser: The last SourceMount declared will require this Username
; in order to become a source for this mount. Note: if you are running
; this mount in shoutcast compatibility mode, this is not required. However
; it’s best to set this anyhow as it allows your encoder users to administrate
; their mounts from a CNTRL app or web panel.
SourceUser=telos
; SourcePass: This is the last Source Mount’s password, this is required
; for all connecting encoders. Mounts without passwords are invalid.
SourcePass=telos1
; SourceUserMax [*5]: This particular mount’s UserMax, if all of your source