Oki 390 - Manual (Page 115)

108 Appendix D: Priner Commands
Overscore
Graphics, 8-Pin Mode
For all 8-pin graphics
commands the number of
dot columns of graphic
data=n
1
+ (n
2
x 256)
Single Density Graphics
Double Density Graphics
Quasi-Double Density
Graphics
Quadruple Density
Graphics
Set Aspect Ratio for Bit
Image Graphics
ASCII: ESC _ n
Dec: 27 95 n
Hex: 1B 5F n
ASCII: ESC K l h [graphics data]
Dec: 27 75 l h [graphics data]
Hex: 1B 4B l h [graphics data]
ASCII: ESC L l h [graphics data]
Dec: 27 76 l h [graphics data]
Hex: 1B 4C l h [graphics data]
ASCII: ESC Y l h [graphics data]
Dec: 27 89 l h [graphics data]
Hex: 1B 59 l h [graphics data]
ASCII: ESC Z l h [graphics data]
Dec: 27 90 l h [graphics data]
Hex: 1B 5A l h [graphics data]
ASCII: ESC n n
Dec: 27 110 n
Hex: 1B 6E n
IBM
Function Commands
(ASCII, Decimal, Hexadecimal)
Prints a continuous overscore over all
text characters except for tab spaces.
n=0 to 255
n=odd: start overscore
n=even: stop overscore
Dot density 60 dpi horizontal, 72 dpi
vertical.
Maximum data per line: ML390 Tur-
bo=480: ML391 Turbo=816
l,h=0 to 255: specifies amount of subse-
quent Bit Image bytes received, calculat-
ed as l + (h x 256).
Dot density 120 dpi horizontal, 72 dpi
vertical.
Maximum data per line: ML390 Tur-
bo=960: ML391 Turbo=1632
l, h=0 to 255: specifies amount of subse-
quent Bit Image bytes received,
calculated as l + (h x256).
Same as low speed double density (120
dpi), but printer can't put two adjacent
dots in the same row.
Dot density 240 dpi horizontal, 72 dpi
vertical. Printer can't put two adjacent
dots in the same row.
Maximum data per line: ML390 Tur-
bo=1920: ML391 Turbo=3264
l,h=0 to 255: specifies amount of subse-
quent Bit Image bytes received,
calculated as l + (h x 256).
In PPR emulation, sets ratio of vertical to
horizontal dot density in bit image
graphics. Valid only for ESC K, ESC L,
Notes