Oki 390 - Manual (Page 19)

12 Loading Paper
3. Grasp back of paper separator and un-
snap it from housing, then swing it up
into single-sheet feed position, making
sure that wire feed guide is nestled in
separator.
4. Adjust paper feed guides for width of
paper and drop sheet of paper into
separator. Paper will automatically
feed into printer.
If the sheet of paper doesn’t feed in
properly, the “15” light in the Char-
acter Pitch section at the bottom
right of the control panel will be-
gin flashing. To correct this, press
the SHIFT and RESET buttons si-
multaneously, then reload the
sheet.
Wire feed
guide
Paper
separator
Paper feed
guides
ALARM
CHARA
15
PROP
SHIFT
RESET
Press
Flashes