TP-Link TL-WR941ND - Manual (Page 20)

TL-WR941N/TL-WR941ND Wireless N Router
-13-
Figure 3-9 Quick Setup – Wireless
¾
Wireless Radio - Enable or disable the wireless radio choosing from the pull-down list.
¾
SSID - Enter a value of up to 32 characters. The same name of SSID (Service Set
Identification) must be assigned to all wireless devices in your network. Considering
your wireless network security, the default SSID is set to be TP-LINK_xxxxxx (xxxxxx
indicates the last unique six numbers of each Router’s MAC address). This value is
case-sensitive. For example, TP-LINK is NOT the same as tp-link.
¾
Region - Select your region from the pull-down list. This field specifies the region where
the wireless function of the Router can be used. It may be illegal to use the wireless
function of the Router in a region other than one of those specified in this field. If your
country or region is not listed, please contact your local government agency for
assistance.
¾
Channel - This field determines which operating frequency will be used. The default
channel is set to Auto, so the AP will choose the best channel automatically. It is not
necessary to change the wireless channel unless you notice interference problems with
another nearby access point.
¾
Mode - This field determines the wireless mode which the Router works on.
¾
Channel Width - Select any channel width from the pull-down list. The default setting is
automatic, which can adjust the channel width for your clients automatically.
¾
Max Tx Rate - You can limit the maximum transmission rate of the Router through this
field.
¾
Disable Security - The wireless security function can be enabled or disabled. If
disabled, the wireless stations will be able to connect the Router without encryption. It is