Twin-Star International 33EB304GRS - Manual (Page 4)

Voltage Selector Switch: Figure 2
The voltage selector switch is located inside
the exhaust panel on the top left hand
corner. Carefully insert a flat headed screw-
driver inside the exhaust panel through the
hole in the mesh to change the switch from
240 volts (230 position) to 120 volts (115
position). The unit ships with the switch in the
115v position.
115
230
Section 3: Voltage Selector Switch Location
When wiring the unit for 208/240 volts the
voltage selector switch should be in the 230
volt position. (see figure 2)
When wiring the unit for 120 volts the voltage
selector switch should be in the 115 volt
position. (see figure 2)
Caution:
When changing the voltage selector switch
from 240 volts to 120 volts ensure that the
power supply is turned off.
Important:
Ensure that the incoming power supply
voltage matches the setting of the
voltage selector switch!!!!!!
E-4