Installation & operating instructions – Temco Tool DV1400N/P User Manual

Page 3

Advertising
background image

3

Temco DV1000/1200/1400 Series

76657

Installation & Operating Instructions

This gas appliance should be installed by a qualified
installer in accordance with local building codes and with
current CSA-B149.1 Installation codes for Gas Burning
Appliances and Equipment. For U.S.A Installations follow
local codes and/or the current National Fuel Gas Code.
ANSI Z223.1/NFPA 54
.
FOR SAFE INSTALLATION AND OPERATION PLEASE
NOTE THE FOLLOWING:

1 . This fireplace gives off high temperatures and should be

located out of high traffic areas and away from furniture and
draperies.

2. Children and adults should be alerted to the hazards of the

high surface temperatures of this fireplace and should stay
away to avoid burns or ignition of clothing.

3. CAUTION: Due to high glass surface temperature chil-

dren should be carefully supervised when in the same
room as fireplace.

The embers supplied with your fireplace are
made from a high grade rock wool and should be
handled carefully. Wash your hands immediately
after touching to avoid irritation. The embers
must be placed correctly in order to function
properly.

This appliance may be installed in an aftermarket
permanently located, manufactured home or mo-
bile home, where not prohibited by local codes.
This appliance is only for use with the type of gas
indi-cated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certified kit is used.

IMPORTANT:

PLEASE READ THE FOLLOWING CAREFULLY

Remove any plastic from trim parts before turning the
fireplace ON.
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found
with your furnace heat exchanger or car engine. It
is not unusual for your gas fireplace to give off some
odor the first time it is burned. This is due to the
manufacturing process.

Please ensure that your room is well ventilated

-open all windows.

It is recommended that you burn your fireplace for at
least four (4) hours the first time you use it. If the op-
tional fan kit has been installed, place the fan switch
in the “OFF” position during this time.

WARNING: When purging the gas line, the glass
front must be removed.

�������

��������������

������������

������������������

�������������

��������������������

���������������

4. Under no circumstances should this fireplace be modified.

Parts removed for servicing should be replaced prior to
operating this fireplace again.

5. Installation and any repairs to this fireplace must be per-

formed by a qualified installer, service agency or gas sup-
plier. A professional service person should be contacted to
inspect this fireplace annually. Make it a practice to have
all of your gas fireplaces checked annually. More frequent
cleaning may be required due to excess lint and dust from
carpeting, bedding material, etc.

6. Control compartments, burners and air passages in this fire-

place should be kept clean and free of dust and lint. Make
sure the gas valve and pilot light are turned off before you
attempt to clean this fireplace.

7. The venting system (chimney) of this fireplace should be

checked at least once a year and if needed your venting
system should be cleaned.

8. Keep the area around your fireplace clear of combustible

materials, gasoline and other flammable vapor and liquids.
This fireplace should not be used as a drying rack for cloth-
ing, nor should Christmas stocking or decorations be hung
in the area of it.

9. Under no circumstances should any solid fuels (wood, coal,

paper or cardboard etc.) be used in this fireplace.

10. For safe operation, the glass door must be closed.
11. Do not use this heater if any part has been under water.

Immediately call a qualified service technician to inspect the
heater and to replace any part of the control system and any
gas control which has been under water.

12. Do not operate appliance unless completely installed as per

installation instructions.

13. This appliance may be used in a bedroom installation. Install

in accordance with local building codes and regulations.

14. Never use your fireplace as a cooking device.

DV1000 / DV1200 / DV1400

Certified To

ANSI Z21.88-2005 / CSA 2.33-2005 / UL 307B

Vented Gas Fireplace Heater

WARNING: Check with your electronics manufac-
turer before installing a television or other elec-
tronic device above this fireplace.

Advertising
This manual is related to the following products: