Technicolor - Thomson DTH 7000 E - Manual (Page 10)

Installation A
utomatic channel search
10
In each region, TV stations are broadcast on different channels. Your DMR cannot be
factory-set to receive the TV channels of your area. You will have to set up the channels
by following the automatic procedure recommended below.
5. Select your country of residence using the
ˆ
or ‡ , keys, and press ok .
ð The Automatic line is already selected. Press
ok .
ð The screen displayed is a set-up screen for the allocation of input terminals.
6. If you connected your devices as indicated on page 8, check that Antenna-Cable has
been allocated to Antenna-Cable, otherwise change the allocation using the †
key on
the remote control.
7. Then select the Done line with the ˆ
, key
and press ok .
ð An installation window will appear. A blue
cursor shows the progress in the set-up of the
channels. You will need to wait a fair amount
of time. When all the channels that you can
receive in your area have been stored
100 %
is indicated. The number of channels found is
indicated by
xx channels found.
Press ok .
Your DMR is equipped with the AV Link function. This function simplifies channel set-up by
downloading them from an AV Link or similar television set (Easy Link, Smart Link, Megalogic, etc.)
which is already set up. The channels downloaded in this way keep the same characteristics as those of
your TV set (same number, name, etc.). Your DMR’s AV Link downloading function is enabled (factory
setting). If you want to disable this function, select
AV Link - Off in the Installation menu (within
the Setup menu).
• Other terminal settings (set with the
‡ˆ
/
…†
keys).
Antenna-Cable : for an antenna connection on the
ANTENNA-CABLE IN socket of your DMR (
k
N° 1
on page 8)
AV2-SAT-CABL. : leave Nothing . Installation
with a satellite receiver or cable terminal is explained
on page 14.
Other : for the connection of another device (VCR,
etc.).
Nothing : If no device is connected to the socket
concerned.
DTH7000-EN 23/08/02 10:24 Page 10