Technicolor - Thomson DTH 7000 E - Manual (Page 15)

EN EN
Satellite set-up
15
DMR / satellite or cable receiver settings
1. Switch on your TV set, your DMR, then your satellite or cable receiver.
2. Place the receiver on channel 002.
With your DMR’s remote control, carry out the following settings:
3. If the main menu is not displayed, press the menu key on the remote control.
4. Select the Setup line using the ˆ
or
‡
, keys, and press ok to validate.
5. Select the Installation line using the ˆ
or
‡
, keys, and press ok to validate.
ð The Interactive setup line is already selected. Press
ok .
Display language and country of residence
6. Choose a display language for the following screens.
7. Select your country of residence using the
ˆ
or
‡
, keys, and press ok .
ð The Automatic line is already highlighted, press ok .
ð The screen which appears is a set-up screen for the allocation of input terminals.
8. If you connected your devices as indicated on page 14, check that Satellite Receiver
has been allocated to AV2-SAT-CABL, otherwise change the allocation using the †
key.
9. Then select the line Done and press ok .
ð An installation window will appear. A blue cursor shows the progress in the set-up of the
channels. When all the channels that you can receive in your area have been stored,
100 % is indicated.
Press
ok .
ð From now on, follow on-screen instructions appearing in
the various windows. If need be, refer to the additional
explanations given below.
Cable Receiver or Satellite Receiver :
to connect with a satellite or cable receiver
terminal on the AV2 socket of your DMR
(connection shown on page 14). The other
settings are explained on page 10.
DTH7000-EN 23/08/02 10:24 Page 15