Technicolor - Thomson DTH 7000 E - Manual (Page 52)

52
Appendix U
niversal remote control
The remote control supplied with your DMR enables you to control other devices such
as a TV set, a satellite receiver or a hifi system. To do this, you must program your
remote control using one of the 3-digit codes given at the end of this manual.
Programming the remote control
About the TV/DMR key
4. Release down menu key.
• Try to operate the
equipment by switching
it on/off with the
B B key.
• If it does not work,
repeat from step 2 with
another 3-digit code.
1. Look for the 3-digit code number(s) that correspond(s) to your device in the list of makes
below (Circle the code(s) with a pencil, for instance).
2. Place the selector on the
position of the device to be
controlled.
• Not all TV can be operated with this
universal remote control.
• Try to find the most efficient code for your
brand (for brands with several codes).
• Try out which functions you can control with
the remote control.
• If you have replaced the batteries of
the remote control, perform the
remote control set-up again.
• T h e h i f i / s a t p o s i t i o n
enables you to control
either a hifi system or a
satellite receiver.
3. While holding down the
menu enter the 3–digit
code with the number
keys.
Other codes at the end of the
manual.
Examples
BRANDT . . . . . . . . . . .000,001,010,020
FERGUSON . .001,003,004,000,010,020
NORDMENDE . . . . . .001,010,020,000
SABA . . . . . . .000,001,005,010,019,020
TELEFUNKEN . .000,001,002,010,020
THOMSON . . . . . .000,001,002,010,020
With some TVs, video from your DMR takes priority and is displayed on the screen. In this
case, you can no longer change channels on the TV, either by using your DMR’s remote
control unit set to the TV position (by pressing the
key) or by using the TV’s remote
control unit. You can therefore no longer record one channel’s programmes on the hard disk
of your DMR while watching another channel on the TV. If you want to watch one channel
while recording programmes on another channel, you must change the AV1 output
connection setting by selecting Video instead of RGB in the Options menu. See pages 50 and
51 of your user manual for details of how to change the AV1 output connection setting.
DTH7000-EN 23/08/02 10:24 Page 52