Topcom BUTLER 5020 - Manual (Page 58)

The display will show the active base station if the handset is already subscribed to that base station. If it is not
subscribed to a base station, the Park code must be entered immediately.
- Press OPT. (option)
- Select NEW by using the UP and DOWN keys.
- Press OK to confirm.
- Enter the Park Code, PARK?:
- Press NEXT to confirm.
- Enter the Base Pin Code, BASE PIN?: (standard 0000)
- Press OK to confirm.
- The display shows << WAIT >> until the handset has found it’s base station.
If the handset does not find the selected base station, the handset will return to standby mode after 2
minutes.
If the PIN code is wrong, the display shows << FAIL >>. Press ESC to leave the setting.
- Enter a name for the handset, NAME: (use the alphanumerical keypad)
- Press OK to confirm.
The base station will automatically assign a handset number (1-5). This number will be shown on the
display as the assigned internal number.
- Press OK to confirm.
- If you want to leave the setting, press ESC for more than 2 seconds.
5.11. Removing subscription of a handset to a base station
When a handset is subscribed to multi base stations, you are able to remove the subscription of a
specified unit. The active base station cannot be removed.
- Press MENU when the unit is in standby mode..
- Select SYSTEM by using the UP and DOWN keys.
- Press OK to confirm.
- Select SUBSCRIPTION by using the UP and DOWN keys.
- Press OK to confirm.
- Press OPT.
- Select DELETE by using the UP and DOWN keys.
- Press OK to confirm.
- Select the desired base station by using the UP and DOWN keys.
- Press OK to confirm.
5.12. Change the assigned name and number from a subscribed base station
- Press MENU when the unit is in standby mode..
- Select SYSTEM by using the UP and DOWN keys.
- Press OK to confirm.
- Select SUBSCRIPTION by using the UP and DOWN keys.
- Press OK to confirm.
- Press OPT.
- Select EDIT by using the UP and DOWN keys.
- Press OK to confirm.
- Select the desired base station by using the UP and DOWN keys.
- Press OK to confirm.
- Change the name of the base station, NAME: (use the alphanumerical keypad)
To remove a character, press C.
- Press OK to confirm.
58
Butler 5020
Handl. B5020 euro 18/3/02 12:11 pm Page 58