Turbosound TXD series - Manual (Page 21)

user manual
TXD series
MOUNTING AND FIXING
A versatile range of mounting hardware is available that allows
enclosures to be used in a variety of ways, in either mobile
sound reinforcement applications or permanent installations.
A pole mount / tripod stand fitting is fitted to the bottom of the
TXD-081, TXD-121 and TXD-151 full range cabinets. Use this
pole mount facility with either optional Turbosound PA-60, PA-
90 or PA-100 35mm diameter poles, or conventional loudspeaker
tripod stands. Doing so will raise the loudspeaker above the
heads of an audience, providing better sound coverage from a
single enclosure. A matching pole mount socket is provided on
the top of the TXD series low frequency enclosures to accept the
various poles.
TXD series cabinets, including low frequency enclosures, can be rigged in permanent installations
using optional M10 shoulder eyebolts. The top of each cabinet is provided with two internal
threaded rigging points, and a further rigging point is provided on the back panel which is used to
vary the amount of downward angle. As supplied, these rigging points are fitted externally with
M10 countersunk slot-head screws. To facilitate rigging of the enclosure simply remove these M10
screws and replace them with M10 x 18mm shoulder eyebolts using a suitable thread locking
compound to avoid the possibility of loosening (please refer to Appendix C: Use of thread locking
compounds at the back of this manual). Note: Eyebolts must have a thread length of at least
18mm (3/4”).
NOTE: The rigging points are designed to suspend single enclosures only. There is no facility to
hang an additional cabinet below a flown TXD series enclosure.
TXD series manual
page 21