Tatung TDR-22XX - Manual (Page 13)

TATUNG TDR series Digital Recording System Page 9
CHAPTER 3: SETUP MODE
The first screen of the setup mode will be the channel setting as the following picture
The control buttons contained in the main screen are described below:
1. Channel
Click on this button to setup the channel and channel name. There are two
different ways to setup the channel-automatically scan and manually
designate. You can also set the name for each channel.
2. Schedule
Click this button to setup the recording schedules. There are 16 recording
groups and three recording modes (continuous, motion, sensor) can be
separately set up for your application. Alarm output can also be set up
separately.
3. Speed
Click to assign the recording speed and other options. The recording
speeds include speeds on normal recording, motion recording, and sensor
recording. You can also set up the times for display sequence, post alarm
and post motion in this mode.
4. Color
Click to adjust the image color, including the adjustment of Brightness,
Contrast, Color (saturation), and TINT for each individual channel.
5. Motion
Click to assign the motion function. You can set up each individual
channel’s motion detection area (up to 10 zones for each channel),
sensitivity, and the beep time for motion detection.
Note: For TDR-2209, CH 10 to
CH 16 will be empty by the
factory’s setting. For TDR-2204,
CH 05 to CH 16 will be empty by
factory’s setting