Tatung TDR-22XX - Manual (Page 22)

TATUNG TDR series Digital Recording System Page 18
3.5 Motion
This function button (as shown below) can be used to setup the motions.
1. Select channel
Select the channel from 1 to 16.
2. Set up motion detection zone.
Setup the motion detection zone for each channel by click and drag. It would be
seen in red square (Maximum 10 areas per camera).
3. Set up the MISC options.
Motion beep
In motion recording mode, BEEP sound (if the speaker was included in the
system) can be activated/inactivated by checking the box or not. Beep time can
be also be adjusted by dragging the cursor.
Click on this button to setup the motion, the screen display as the below
(Please following the 4 steps)
Note: If no detection zone was
defined, system will recognize
the whole windows as a
detection zone.
Note: After the camera is
motion activated in Schedule
Setup Mode and after the
detect zone is set, this
channel will be motion-
activated in the define area. If
anything falls in this area, the
detected motion will be seen
in a lot of small blue squares.
And red wording “MOTION
DETECTION” will be blinking.