Connecting to the network, Installation method – Toshiba DEV002Z User Manual
Page 11
E6581295⑥
- 10 -
4. Connecting to the network
4.1. Installation method
(1) Attach DeviceNet cable to DeviceNet connector. (Refer to Section 2.1).
(Be careful not to short-circuit adjacent terminals on DeviceNet connector).
<Recommended cable>
Thin branch cables: DeviceNet-specific thin cable.
<Tightening torque>
0.5 - 0.6 N·m
Recommended screwdriver: Small flat-blade screwdriver (blade thickness: 0.6mm,
blade length: 3.5mm or less)
(2) Please set the terminating resistance if needed.
<Terminating resistance specification>
1/4 W - 121 ohm, 1% Metal Film
(3) Using the DIP switch on the DeviceNet
option
, set a MAC ID number and a baud rate.
(Refer to Section 4.3).
(4) Once all the parameters are set, the power must be cycled to the VF-AS1/PS1 for
these changes to take effect. (Refer to Section 5.)