TP-Link TL-SL3452 - Manual (Page 52)


Section 7. Configuring Interfaces
This section contains the following topics:
Configuring Ports
Configuring LAGs
Configuring VLANs
7.1 Configuring Ports
The Interface Configuration Page contains fields for defining port parameters.
To define port parameters:
1. Click
System > Bridging Config > Interface > Interface Configuration. The Interface Configuration Page opens:
Figure 65: Interface Configuration Page
The Interface Configuration Page is divided into the
following sections:
Interface Configuration Ports Table
Interface Configuration LAG Ports Table
The Interface Configuration Ports Table contains the
following fields:
Interface — Displays the port number.
Port Status — Indicates whether the port is currently
operational or non-operational. The possible field values are:
– Up — Indicates the port is currently operating.
– Down — Indicates the port is currently not operating.
Port Speed — Displays the configured rate for the port. The port type determines what speed setting options are
available. Port speeds can only be configured when auto negotiation is disabled. The possible field values are:
– 10 — Indicates the port is currently operating at 10 Mbps.
– 100 — Indicates the port is currently operating at 100 Mbps.
– 1000 — Indicates the port is currently operating at 1000 Mbps.
Duplex Mode — Displays the port duplex mode. This field is configurable only when auto negotiation is disabled,
and the port speed is set to 10M or 100M. This field cannot be configured on LAGs. The possible field
values are:
– Full — The interface supports transmission between the device and its link partner in both directions simultaneously.
– Half — The interface supports transmission between the device and the client in only one direction at a time.
Auto Negotiation — Displays the auto negotiation status on the port. Auto negotiation is a protocol between two link
partners that enables a port to advertise its transmission rate, duplex mode, and flow control abilities to its partner.
Advertisement — Defines the auto negotiation setting the port advertises. The possible field values are:
– Max Capability — Indicates that all port speeds and duplex mode settings are accepted.
– 10 Half — Indicates that the port advertises for a 10 Mbps speed port and half duplex mode setting.
– 10 Full — Indicates that the port advertises for a 10 Mbps speed port and full duplex mode setting.
– 100 Half — Indicates that the port advertises for a 100 Mbps speed port and half duplex mode setting.
– 100 Full — Indicates that the port advertises for a 100 Mbps speed port and full duplex mode setting.
– 1000 Full — Indicates that the port advertises for a 1000 Mbps speed port and full duplex mode setting.










