Tunturi T20 - Manual (Page 5)

G B
5
O W N E R ' S M A N U A L • T 2 0
shows heart rate. The ELEVATION Indicator is
on and the HEART RATE / ELEVATION Display
shows elevation level.
B. PROGRAM DISPLAY: Shows the information in
action and chosen by pressing “SCAN/SELECT”
Key. P1 to P8 and 3 user-settings modes can be
chosen from.
C. TIME DISPLAY:
Shows the exercising time with
counting up or down. While the treadmill is not
running and the SAFETY KEY is on, it can be
chosen by pressing “ENTER” then adjusted by
pressing “+” or “-“. The range of counting up
is from 00:00 to 99:59 and 10:00 to 99:00 with
counting down. While counting down to 00:00, the
monitor will beep 12 times then the treadmill will
stop.
D. SPEED DISPLAY:
Shows the speed that the treadmill
is providing. It can be adjusted by pressing
“SPEED+” and “SPEED- “ keys from 0.5 to
12,5MPH or 0.8 to 20 KPH.
E. DISTANCE DISPLAY: Shows the distance with
counting up or down while treadmill is not running
and SAFETY KEY is on, it can be chosen by
pressing “ENTER” then adjusted by pressing
SPEED +/- or ELEVATION +/- .The range of
counting up is from 0.00 to 999KPH/MPH and 999
to 0.00 with counting down. While counting down
to 0.00, the monitor will beep 12 times then the
treadmill will stop.
F. KCAL DISPLAY: Shows the kcal with counting
up or down while treadmill is not running and
SAFETY KEY is on, it can be chosen by pressing
“ENTER” then adjusted by pressing SPEED +/- or
ELEVATION +/- .The range of counting up is from
0.00 to 999 KCAL and 999 to 0.00 with counting
down. While counting down to 0.00, the monitor
will beep 12 times then the treadmill will stop.
G. HEART RATE /ELEVATION DISPLAY: The default
value shown is the pulse rate and the HEART
RATE Indicator is on. It switches to the value of
elevation % while adjusting and the ELEVATION
Indicator is on.
OPERATION INSTRUCTIONS (PLEASE READ
CAREFULLY BEFORE USING)
A. SAFETY TIPS:
To start, turn on the power and attach the Safety Key
to the monitor. Notice that the machine does not
work and off the LED display without the Safety Key
attached. Please clip the other end of the Safety Key
to the user before exercising to ensure the machine
will stop in case the user accidentally runs off the
treadmill. Should that happen, the Safety Key will be
off the monitor and the treadmill will stop at once to
avoid further injury.
B. PROGRAMS SELECTION:
There are 11 programs including 8 preset programs,
and 3 User Setting programs to choose from by
pressing the “SCAN/SELECT” key.
C. PROGRAM GRAPH:
The graphs in the PROGRAM Display are the
speed profile but incline also will change during the
exercise. There are total 20 columns in the display.
Without the value of TIME set, each program will
last 20 minutes that is 1 minute of each column’s
interval. With the value of time set, each interval
varies. For example, if the value of time is set to
10 minutes counting down, each interval will be 10
minutes dividing by 20 intervals (10/20=0.5) that is
30 seconds.
D. EXERCISING WITH A SPECIFIC GOAL:
In any programs, user may change the values of TIME
before exercising. Press “ENTER” key to select each
of them, and “SPEED + & SPEED –“ to change the
value. Without changing any of the values and all are
0; users can run as long as possible until it is turned
off. Users may also put the desire TIME value to
count down. For example, TIME is set to 10 minutes,
and then the treadmill will stop after 10 minutes.
E. HEART RATE:
There are two ways to measure your heart rate. One
is using the hand-pulse sensor. Another is using chest
belt. The hand-pulse sensor is setting for the first
priority. Please use both hands to gently hold the
Hand Pulse Sensors. There are 2 sensors and 2 pieces
of metal part each sensor. Each hand must gently hold
both metal pieces to trigger the measuring. The pulse
rate will show in the “HEART RATE/ELEVATION”
Display. Customer also can use chest belt to measure
your heart rate.
BASICS ON EXERCISING
ABOUT YOUR HEALTH
• Before you start any training, consult a physician to
check your state of health.
• If you experience nausea, dizziness or other
abnormal symptoms while exercising, stop your
workout at once and consult a physician.
• To avoid muscular pain and strain, begin and end
each workout by stretching.
ABOUT THE EXERCISE ENVIRONMENT
• Make sure the exercise environment has adequate
ventilation. To avoid catching cold, do not exercise in
a draughty place.
• Place the treadmill on a firm, level surface. Allow
120 cm or 4 feet of clearance behind the treadmill
and 60 cm or 2 feet on either side and in front of the
treadmill.
•
We recommend that the equipment is placed on a
protective base.
ABOUT USING THE EQUIPMENT
• Always unplug the treadmill from the electrical
outlet after each training session.
•
Only one person may use the equipment at a time.
• Keep hands clear of any moving parts. Never place
hands, feet or any other objects under the treadmill.
• Wear appropriate clothing and shoes when
exercising. Make sure your shoelaces are properly