TRENDnet BE1-87G - Manual (Page 11)

1-6 BE1-87G - General Information
Pickup Accuracy
(1 Ampere) For I
R

1 ampere, ±5% of the operate pickup characteristic or 25
milliamperes whichever is greater. Actual operating characteristics are
shown in graph format in Section 5,
Testing And Setting the relay.
For I
R

1 amperes, up to a maximum of 4 amperes, ±8% of the operate
pickup characteristic or 150 milliamperes, whichever is greater. Actual
operating characteristics for pickup values between 1 and 4 amperes are
shown in graph format in Section 5,
Testing And Setting the relay.
Dropout Greater than 90% of operate characteristic.
Timing Less than 30 milliseconds at 10 times pickup setting; 70 milliseconds
maximum. See Section 5,
Testing And Setting the relay, for the pickup
response timing curve.
Power Supply Power for the internal circuitry may be derived from ac or dc external power
sources as indicated in Table 1-1.
Table 1-1. Power Supplies
Type
Nominal Input
Voltage
Input Voltage
Range
Burden at Nominal
(Maximum)
K (Mid Range) 48 Vdc 24 to 60 Vdc 5.0 W
J (Mid Range) 125 Vdc
120 Vac 62 to 150 Vdc
90 to 132 Vac 5.5 W
14.5 VA
L (Low Range) + 24 Vdc 12 to 32 Vdc 5.5 W
Y (Mid Range) 48 Vdc
125 Vdc
24 to 60 Vdc
62 to 150 Vdc
5.5 W
6.0 W
Z (High Range) 250 Vdc
230 Vac 140 to 280 Vdc
190 to 270 Vac 7.0 W
20.0 VA
+ Type L power supplies may initially require 14 Vdc to begin operating. Once
operating, the voltage may be reduced to 12 Vdc and operation will continue.
Output Contacts Output contacts are rated as follows.
Resistive:
120/240 Vac Make and carry 30 amperes for 0.2 seconds, carry 7 amperes
continuously, and break 7 amperes.
125/250 Vdc Make and carry 30 amperes for 0.2 seconds, carry 7 amperes
continuously, and break 0.3 ampere.
Inductive:
120/240 Vac, Make and break 0.1 A (L/R = 0.04).
125/250 Vdc Make and break 0.1 A (L/R = 0.04).
Targets Magnetically latched, manually reset target indicators may be optionally
selected as either internally operated or current operated. Current
operated targets require a minimum of 0.2 ampere through the output trip
circuit and are rated at 30 amperes for 1 second, 7 amperes for 2 minutes,
and 3 amperes continuously.