TRENDnet BE1-87G - Manual (Page 21)

4-4 BE1-87B - Installation
Stabilizing Reactor
The stabilizing reactor for a three-phase relay is mounted on the rear of the relay. For projection mounting
or convenience, the stabilizing reactor can be removed and relocated. Rewire in accordance with the
procedures and illustrations in this section. To remove the stabilizing reactor, remove four screws holding
the reactor to the mounting plate. To remove the mounting plate, remove two five-sixteenths by eighteen,
hex head bolts. The stabilizing reactor outline dimensions and panel drilling diagrams are shown in
Figures 4-6 and 4-7.
Figure 4-6. Outline Dimensions for External Reactor Chassis 9 1708 18 100