TP-Link TL-WN7200ND User Manual
Page 21
150Mbps High Power Wireless USB Adapter
User Guide
TL-WN7200ND
- 16 -
)
Note:
To build a successful connection by QSS, you should also do the corresponding configuration of
the Access Point for QSS or WPS function meanwhile.
I. PBC
Method
If your Access Point is equipped with a push-button for Wi-Fi Protected Setup, you can connect
the adapter to the Access Point by Push QSS Button method.
Step 1 Press the QSS button on your Access Point device.
Step 2 Click the QSS button (marked by the red circle) on the screen as Figure 3-9.
Figure 3-9 QSS- QSS BUTTON mode
Or: Press and hold the QSS button on the adapter (shown on the following figure) for 2 or 3
seconds.
II. PIN
Method
If your Access Point supports Wi-Fi Protected Setup and the PIN method, you can add the
adapter to the network by the following two ways: