TP-Link TL-WN7200ND - Manual (Page 9)

TL-WN7200ND 150Mbps High Power Wireless USB Adapter User Guide
- 4 -
Chapter 2 Installation Guide
2.1 Hardware Installation
1. Connect one end of the USB cable to the Adapter.
2. Connect the other end of the USB cable to the USB port on your computer. Because the
Adapter gets its power from the host, there is no external power supply. The LED should light
up when the Adapter is plugged in and the PC is on.
2.2 Software Installation
2.2.1 Overview
For Windows 7, the driver will be searched and installed automatically after you finish hardware
installation.
For Windows 2000/ XP/ Vista, the Adapter’s Setup Wizard will guide you through the installation
of the Utility and drivers. Before you install the software, please connect the USB adapter with
your computer by USB cable. After that, you will be prompted “Found New Hardware Wizard”,
click the Cancel button, and run the Setup Wizard program on the CD-ROM.
The Setup steps for Windows 2000/ XP/ Vista are very similar, so the following installation guide
takes Windows XP for example.
2.2.2 Installation Guide
1. Insert the Resource CD into your CD-ROM drive, and open the folder named TL-WN7200ND.
Double-click Setup.exe in the proper folder according to your operating system to start the
installation, then the following screen for preparing setup will appear.