Texas Instruments 3000 - Manual (Page 167)

Memory Device Drivers
Memory Manager Error Messages
Error messages displayed by the memory manager are divided into two groups. The
following first group displays general memory manager errors.
Invalid parameter specified - One of the parameters specified on the command line in
your CONFIG.SYS file is invalid.
Expected equal after parameter - One of the parameters on the command line expected an
equal sign (=) after the parameter, but none was found.
Invalid number specified - A number was expected, but an alphabetic character or a
number containing invalid characters was found.
Context depth must be between 1 and 32 - An invalid number of contexts was specified.
The number specified cannot be zero or greater than 32. See "Contexts" parameter earlier
in this appendix.
Invalid page frame address specified - The page frame address specified is not available
for banking. The memory manager requires a 64-KB area above A000 that is free of
expansion ROM and RAM. See 'Start" parameter earlier in this appendix.
Number of handles must be at least 3 - The number of handles specified is less than 3.
The number of handles specified must be between 3 and 255. See "Handles" parameter
earlier in this appendix.
Number of handles cannot exceed 255 - The number of handles specified is greater than
255. The number of handles specified must be between 3 and 255. See "Handles"
parameter earlier in this appendix.
F-12 Configuring Memory