Handling the battery pack, Removing the battery pack – Texas Instruments 3000 User Manual
Page 51
Handling the Battery Pack
Removing the Battery Pack
The internal NiCad battery pack and its cover are built as one unit; do not try to separate
the cover from the battery pack. Remove the battery pack from the computer as follows.
1
Turn off the computer and disconnect the AC Adapter and any other
external device connectors.
2.
Close the display and carefully lay the computer upside down on a
padded surface.
3.
Slide the battery pack locking latch toward the or
(open padlock)
symbol.
4.
Holding the computer in one hand, carefully turn the computer right
side up and allow the battery pack to fall out of the computer into your
other hand.
You now can operate the computer solely on ac power via the AC Adapter, or you can
install a fully charged battery pack for battery operation.
Getting Started 3-9