The First Years VIA 1450 - Manual (Page 17)

Section 7 - Installation and Use
1
2- Leveling base.
. Level Vehicle
-
- Place seat in base and check
level indicator to see if base is
level. LEVEL is indicated
by the ball being
completely in the
green area.
- Pull out on the yellow
release knob and slide the angle
foot to raise the base or to lower
the base angle.
-
Check to make sure vehicle
is on a level surface.
The base is NOT level and seat
back is NOT at 45 degree unless
the ball is in the green.
NOTE: If needed, a towel or
pool noodle can be used for extra elevation
and angle adjustment.
Base Installation - 7.1
16
↑
Rear of Vehicle
This carrier must always
be used with the base.
