4000000782_i450 instructions__pg18_en.pdf – The First Years VIA 1450 User Manual
Page 19
Section 7 - Installation and Use
2-
Press down on base with knee,
tighten auto belt and insert buckle
tongue into buckle.
Close and secure “Lock Off” to
eliminate slippage.
Pull on auto
safety belt to ensure the auto buckle
is secure.
3-
CHECK level indicator to ensure the
ball is in the green area.
Pull out on
the yellow release knob and slide
the angle foot to raise the base or
to lower the base angle.
4
-
CHECK base at safety belt path
for movement. Base should not
move more than 1 inch in any
direction.
5
- If base moves, repeat steps until
all safety steps are met.
-
After Ball is in the green area on
Level indicator, open Lock Off
and thread auto safety belt through
the labeled “Belt Here” auto safety
belt path.
7.2.1-Auto Belt - Base Installation
with Lap and Shoulder Belt
1
Rear of Vehicle
Shoulder
Belt
Lap Belt
18