TC Electronic G-Force - Manual (Page 19)

RECALL
17
The Recall Display
Select which blocks will be
loaded from new preset
Preset name ROM/USER/CARD
bank selector
General
Select section
Is used to point to a certain block that you want to recall
alone. Should be set to “All” when you want to recall a
complete preset. (default setting)
Bank
Is used to select which bank you would like to recall from,
ROM (factory presets), User, or Card (only available when
a pc-card is inserted).
Preset
Dial the Value wheel to preview the presets. Press ENTER
to recall.
Recalling a Preset
• Set cursor at “Bank” section using the PARAMETER
wheel.
• Select which bank to recall from using the VALUE wheel.
• Select “Preset” section using the PARAMETER wheel
(see illustration above)
• Select which preset to recall using the PARAMETER
wheel.
• Press ENTER.
Preserving the tail of Reverbs and Delays at preset
change
Spillover from one preset to another can be obtained by
using the same sub-algorithm, and combination of Mute
mode = “Fx In” and bypassing the current block.
Example: If you want to leave a Delay tail hanging over a
preset change, you must be sure to keep the same sub-
algorithm in both presets. In addition to that you should
select the “Fx In” Mute mode and just bypass the Delay
block in the second preset.
NOTE: Changing parameters like the Feedback or Mix over
a preset change can kill the Delay.
Optimal preset change
Since the change from one preset to another can contain
drastic changes in level and Routing, artifacts may occur if
the preset is changed while playing.
To obtain the best preset change while playing, you should
keep Routings as even as possible.
Example: When changing from a preset containing Reverb
and Delay, to a preset containing only Reverb you should
just bypass the Delay block instead of removing it (that will
also enable you to obtain spillover from the Delay block)
Recalling a single effect
It is possible to load a single effect setting into an
existing Routing, e.g. if you are building a new preset
and have come up with a really nice Reverb and Delay
but would like to add that Chorus sound you designed
last week. Here is what you do:
Press Recall, and move the cursor to the Select parameter
using the Parameter wheel.
Now use the Value wheel to point to “CHO” (Chorus). Move
the cursor back to the Preset parameter and use the Value
wheel to scroll through the presets (remember to set the
bank, you wish to Recall from).
NOTE: the G-Force will now scroll through only presets
containing the desired effect.
Press Enter to Recall the desired effect. The G-Force will
now update your current preset with the new effect, and
return to the current preset.