TC Electronic G-Force - Manual (Page 46)

THE BLOCKS
44
One Tap Delay
Time
Sets the delay time. Maximum delay time is 1480 ms.
Tempo
The Tempo parameter sets the relationship to the global
Tempo e.g. if you set it to 1/4T you will get quarter note
triplets of the tapped tempo. 1/4 equals the BPM (tapped
Tempo).
If you select “Ignored” the current parameter will use the
Preset value and will not be affected by the Global
Tempo.
Feedback
Adjusts the amount of Feedback.
Pan position
Controls the panning of the Delay.
Lowcut
Cuts off frequencies lower than the selected. The slope of
the filter is 12dB/octave.
Highcut
Cuts off frequencies higher than the selected frequency.
So if you feel that there is too much treble in your signal,
you remove this by adjusting the highcut filter down. The
slope of the filter is 12dB/octave.
Mix
Mix between direct sound and effect.
In Level
Controls the input level of the block.
Out Level
Controls the output level of the Delay block
Mute mode
See Mute mode in the introduction of this chapter.