TC Electronic G-Force - Manual (Page 28)

MODIFIER
26
Modifiers
This is the display where you set up the parameters
for the internal modifiers. Use the Parameter wheel to
select the modifier you want to edit and press Enter to
access the parameters of the current modifier.
Pressing Enter will enable you to enter into the current
selected Modifier. Here is an explanation of the param-
eters in the Modifiers.
Envelope Follower
The Envelope follower is used on effects that you would
like to respond to the input signal like touch-wah or
dynamic delay. The Envelope follower will perform the
same dynamic movement as the input, but you can change
the response time by using the Attack and Release.
Attack - Sets the amount of time before the ENV
reacts to the input signal.
Release - The time that the ENV continues to work after
the input signal stopped.
Pitch
To get optimal precision from the Pitch detection in the G-
Force you must set best matching range according to the
instrument you are playing.
Select between:
6s GTR D-E
Default setting for a 6 string guitar.
Accepts also the common dropped D
tuning.
7s GTR A-E Use this tuning for a 7 string
guitar. The G-Force responds to notes as
low as A. However, the precision in such
a low range may vary depending on your
type of guitar setup.
4s Bass D-E Matches the range of a 4 string bass.
Glide time
With this parameter you can set a minimum time that the
parameter should use to go from maximum to minimum or
vice versa, meaning that even though you move your
expression pedal from min. to max. in a split second, the
current parameter will still take some time to go through the
same range.
Press Exit to leave the Link display.
Each modifier can be connected to several parameters at
the same time but each parameter can have only one
source.
The maximum number of connections that can be made on
the matrix is 20.
Default parameter setting
The default setting of a Matrix connected parameter at
Recall is equal to its setting in the Edit parameter display.
Example: The Reverb mix level is set up to be controlled
by a pedal, and the Mix parameter in the Edit parameter
display is set to 15 %. When this preset is Recalled, the
Reverb Mix will be 15%, and at first movement of the
pedal, you will be in total control of the parameter.
If you want to remove all links of the Matrix, press
Exit twice and you will see a pop up box asking you
to confirm with Enter or abort with Exit.