TC Electronic G-Force - Manual (Page 58)

56
SELF TEST
PRESS THE BYPASS KEY, WHILE POWERING UP, TO
ACCESS THE SELF-TEST AND SELECT »RUN TEST
PROGRAM«
Turn the Value Wheel to scroll through Self tests
Key test
Select Key test by pressing Enter.
The keys must be pressed in the order they are requested
by the G-Force to pass the test.
Press Exit to leave Key test.
In/Out knobs test
Select In/Out knobs test by pressing Enter.
Turn the In/Out knobs to 30 and back to 0 to pass test.
Press Exit to leave In/Out test.
Parameter + Value Wheel test
Select test by pressing Enter.
Turn the Value and Parameter wheel to 30 and back to 0
to pass test. Press Exit to leave Adjust Wheel test.
LED test
Select LEDs test by pressing Enter.
Turn Adjust Wheel to test the LEDs. The test is “ok” when
none Leds are lit.
Press Exit to leave Led test.
Display test
Select Display test by pressing Enter.
Press Enter to check that all pixels are lit. Press any key to
leave the pixel test.
Press Exit to leave Display test.
Analog I/O test
Select Analog I/O test by pressing Enter.
Connect an Analog Output to the Analog Input, which has
to be tested and press Enter.
PPM must show -12 dB to pass test.
Press Exit to leave Analog I/O test.
Digital I/O test
Select Digital I/O test by pressing Enter.
Connect a Digital Output to the Digital Input, which has to
be tested and press Enter.
The AES/EBU output can also be connected to the S/PDIF
input and vice versa.
PPM must show 0 dB to pass test.
Press Exit to leave Digital I/O test.
MIDI I/O test
Select Midi I/O test by pressing Enter.
Connect Midi Out to Midi In.
Prg change 1-128 is send out on Midi Thru. Connect this
socket to a Midi compatible device and confirm the Prg.
changes.
Press Exit to leave Midi I/O test.
Pedal socket test
Select Pedal test by pressing Enter.
Connect a momentary pedal to the Pedal socket.
When pressing the Pedal, the Result should be OK.
When released, the Result should be Not OK.
Press Exit to leave Pedal test.
NOTE: Result of test must be OK if no jack is inserted.
PCMCIA test
Select PCMCIA test by pressing Enter.
Insert PCMCIA card. Note that all Data on PCMCIA card
will be destroyed.
Press Enter to test.
Result reads:
Low battery - Time to change battery in your PCMCIA
card.
Not OK - Try the test using another PCMCIA card.
Press Exit to leave PCMCIA test.
Battery test
Select Battery test by pressing Enter.
Confirm that Result is OK.
Press Exit to leave Battery test.
System test
Select System test by pressing Enter.
Confirm that Result is OK.
Result reads:
Eeprom Not OK - The unit will most likely work OK, the
message is for service matters only.
DSP Not OK - Contact your local dealer.
Press Exit to leave System test.
Power Off - On to start standard software.
Build in test v.2.07