Tandberg Data LTO-2 HH - Manual (Page 15)

Tandberg Data Tape Drive Installation
Tandberg LTO HH Installation and User Manual 11
3.10 Installation Internal Tape Drive
Internal installation of the drive requires a free 5.25-inch half-height bay with an open front in your
computer system.
1. Obtain access to the removable media bay. (Refer to the documentation supplied with your server
for more information on accessing the removable media bay.)
2. Slide the tape drive into the bay, as shown in Figure 3.8.
Figure 3.8 Installing the internal tape drive
3. Secure the tape drive to the bay. (If screws are required, use the screws supplied with the tape
drive, or equivalent. See Section 3.4 Mechanical Installation and Section 3.5 Mounting Screw
Requirements .)
4. Connect the power cable and the SCSI signal cable, as shown in Figure 3.9.
Figure 3.9 Connecting the cables to the Tandberg LTO HH tape drive
3.11 External Tape Drive Installation
After the SCSI controller board has been installed and is working properly, the tape drive can be
installed. Before starting, make sure the power is turned off.
Power Connector
SCSI Connector
SCSI Cable w/term
Power Cable