TOA Electronics M-9000 - Manual (Page 41)

41
11.4.5. Adjustment mode setting items
E Q 1 0 + 1 2 0 7 3 1 5 .
Band number Q Center frequency
Gain
EQ ON/OFF, Band number, Gain, Q, and Center frequency settings (input/output)
The indications on the right of "EQ" turn on and off as the Parameter setting knob is rotated.
When the indication is displayed, EQ is ON and a band number, gain, Q, and center frequency are displayed
in this order from left to right. Use the Parameter setting knob to change each parameter, and the Left and
Right keys to move the setting items.
E V E N T 0 1 – R O U T E O N
FAULT
KEYLOCK
EMERGENCY
1 2 3 4 5 6 7 8
1 2 3 4
5 6 7 8
Event No. Output channels set in Event setting
Input channel set in Event setting
Event activation ON/OFF
Event selection
Rotate the Parameter setting knob to obtain the Event No. of which settings are desired to be adjusted.
The ON or OFF indication shows the corresponding Event activation status when the unit enters the
Adjustment mode.
To adjust the Event's setting, turn the Event activation ON using the input channel ON/OFF key.
Make the Event selection here and press the Right shift key to make the Event-related adjustments.
I N 1 – I N 1 O N + 1 0 0 . :
Input gain
Input ON/OFF
Input ON/OFF and Input gain settings
Adjust the input gain with the input volume encoder.
To stop the sound output temporarily, press the input channel ON/OFF key.
B A S S + 1 2 T R E B L E – 1 0
BASS and TREBLE settings (input/output)
Rotate the Parameter setting knob to set gains.
Press the Right or Left shift key to select BASS or TREBLE, of which gain value that flashes can be adjusted.
L O U D N E S S – O N
Loudness compensation setting (input/output)
Rotate the Parameter setting knob to set the loudness compensation function ON/OFF.
Setting ON boosts low frequencies.